Answered question

How do I activate automatic mode on Freevia, Slidymoove, Evolvia and Exavia?

How do I activate automatic mode on Freevia, Slidymoove, Evolvia and Exavia?

Somfy T.
Somfy T.

Somfy T.

Level
0
-95 / 100
points
Team
Somfy T.
Somfy T.

Somfy T.

Level
0
-95 / 100
points
Team

1- Check that your cells are connected.
When using your gate in automatic mode, standard EN_12 453 requires a set of photoelectric cells to be installed.
If you have already programmed the travel of your gate drive, you should now:
• Delete all settings (see the instructions for your drive)
• Wire the cells
• Reprogramme (see the instructions for your drive)
2- Check the alignment of your cells if you “bus” electronic unit does not recognise the cells. Attention, to check the alignment of the cells, you must replace the cover of the transmitter cell but not that of the receiver cell.
3- Check that the cable section used is 0.75 mm

Did you find this useful ?

No (0)

Yes (0)

0% of users found this answer useful

Top of page

© All rights reserved Somfy - Discover all our home automation solutions: home automation wireless, home automation boxes, our home automation partners, home automation engines, install home automation, home automation in the new home, install it home automation, buy your home automation online, the home automation alarm